Xerox ApeosPort-II 5010

Login Setup/Auditron Administration
347
System Settings
10
Auditron Mode
Select whether to use the auditron administration feature when using the copy, fax, scan, and
print services. Note that Login Setup/Auditron Administration cannot be used unless the
system administrator user ID is set.
For information about the items you can manage, refer to "Authentication and Auditron Administration"
(P.385).
Note • To set the fax charging data, be sure to select [Exit] to exit the System Administration mode,
then once again enter the System Administration mode to make the settings.
• The items appearing depend on the services provided.
Copy Service
Set whether to enable the Login Setup/Auditron Administration feature for copy operations.
Fax Service
Set whether to enable the Login Setup/Auditron Administration feature for fax and iFax
operations.
Scan Service
Set whether to enable the Login Setup/Auditron Administration feature for scan operations.
Print Service
Set whether to enable the Login Setup/Auditron Administration feature for print operations.
Note • A job may be cancelled depending on the settings for "Receive Control" (P.343)
Mailbox Access
Set whether to carry out authentication when printing or retrieving documents stored in a
mailbox.
Note • This item appears when a mailbox is registered.
Login During Printing
Set whether authentication is required when a document in a mailbox is printed.
Login During Retrieval
Set whether authentication is required when a document in a mailbox is retrieved through a
network.