Error Code
453
Problem Solving
15
003-753
O [Cause] The selected resolution was too high for scanning mixed
size documents using the 2-sided feature.
[Remedy] Set [Scan Resolution] to [200dpi], and try again.
003-756
O [Cause] The fax document is all blank.
[Remedy] Check whether or not the document is blank or the
document is correctly loaded.
003-757
O [Cause] The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
[Remedy] Set [Scan Resolution] to [300dpi] or lower, and try again.
003-760
O O [Cause] An incompatible combination of features are specified as
document scan conditions.
[Remedy] Check the selected options.
003-761
O O [Cause] The paper size of the tray selected for auto tray is different
from the paper size of the tray selected for Auto Repeat.
[Remedy] Change the paper size for the tray, or change the [Paper
Type Priority] settings.
003-764
O [Cause] The document has only one page even though [Form
Overlay] has been selected.
[Remedy] Load both the form document and the document to be
overlaid.
003-780
O [Cause] Failed to compress the scanned document.
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to
decrease the data size, or split the data to send it
separately.
003-795
O [Cause] When enlarging/reducing a scanned document to the
specified paper size, the reduction/enlargement ratio value
is out of allowed range.
[Remedy] Take one of the following actions:
z
Manually enter a reduction/enlargement ratio.
z
Change the paper size.
003-970
O Refer to 003-976.
005-275
005-280
005-283
005-284
005-285
005-286
O [Cause] An error occurred in the document feeder.
[Remedy] Turn the machine off and on. Contact our Customer
Support Center.
012-241
012-242
012-244
O [Cause] Finisher malfunction
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
012-246
O Cause] The Booklet Maker is not fully inserted in the C-Finisher
with Booklet Maker.
[Remedy] Fully insert the Booklet Maker, and turn the machine off
and back on.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
