Error Code
497
Problem Solving
15
035-743
035-744
035-745
O [Cause] Unable to communicate. The phone number is incorrect or
the destination machine does not have the feature you
specified.
[Remedy] Check the destination phone number, check also if the
destination machine has the feature you specified, and
then try again.
035-746
O [Cause] The fax network does not respond.
This may be caused by the following. Check them and
then send the fax again.
[Remedy] Is the telephone line correctly connected?
You may not have a fax network contract, or the fax
network may have a problem.
When connecting the machine to the fax network, enter
two pauses after "161" and "162", then dial the telephone
number.
035-747
035-748
O [Cause] The dialing or transmission was interrupted by the <Stop>
button.
[Remedy] No action is necessary.
035-749
O [Cause] The number was re-dialed the specified number of times,
but the destination machine did not respond.
[Remedy] Ask the recipient if the telephone line and telephone
switchboard for the destination machine are defective.
035-750
O Refer to 034-508.
035-751
035-752
O [Cause] The dialing or transmission was interrupted by the <Stop>
button.
[Remedy] No action is necessary.
035-753
O [Cause] Memory became insufficient when attempting to receive
more than 999 pages of fax document.
[Remedy] Ask the sender to reduce the number of pages at one
transmission.
035-754
035-755
035-756
035-757
035-758
035-759
035-760
035-761
035-762
036-500
036-501
036-502
036-503
036-504
036-505
036-506
036-507
O [Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the error persists, contact
our Customer Support Center.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
