Output Format
93
Copy
3
[Watermark - Control Number] Screen
You can set a control number within the range from 1 to 999.
1
Select [On].
2
Set the start number using [ ] and
[ ] or with the numeric keypad.
Off
No control number is printed.
On
A control number is printed. Enter the starting number of the control number.
[Watermark - Text] Screen
Select the text to print on the copy.
1
Select [On].
2
Select any text.
Off
No text is printed.
On
Text is printed. You can select stamp text from 3 preset text or from the text set in the
System Administration mode.
For information on how to register text, refer to "Custom Text 1 to 3" (P.274).
[Watermark - User Account Number] Screen
When using User Administration or Auditron Administration, a user account number is
printed.
Note • [User Account Number] is the No. (User Administration Number) registered by users in
Login Setup/Auditron Administration.
• This screen is displayed when the Auditron Administration feature is enabled. If the Login
Setup/Auditron Administration feature is used, [User Account Number] is displayed even
when no data is collected. In this case, even if [On] is selected for [User Account Number],
the No. registered by users (User Administration Number) is not printed.
1
Select [On].
Off
The user account number is not printed.
On
The user account number is printed. However, nothing will be printed if user
authorization has not taken place.
To Next Page
Loading...
