Xerox B315 - Page 141

MMEENNUU IITTEEMM DDEESSCCRRIIPPTTIIOONN
of the documents even if the job is two-sided printing.
This setting cannot be used when the tray is not fully
inserted or the tray sensor is damaged.
DDeevviiccee OOppeerraattiioonnss
Clear Custom Status
Erase all custom messages.
DDeevviiccee OOppeerraattiioonnss
Clear all remotely-installed messages
Erase all remotely-installed messages.
DDeevviiccee OOppeerraattiioonnss
Automatically Display Error Screens
On*
Off
Show existing error messages on the display after the
printer remains inactive on the home screen for a
length of time equal to the Screen Timeout setting.
SSccaannnneerr CCoonnffiigguurraattiioonn
Scanner Manual Registration
Print Quick Test
Print a Quick Test target page.
Make sure that the margin spacing on the target page
is uniform all the way around the target. If it is not,
then the printer margins must be reset.
SSccaannnneerr CCoonnffiigguurraattiioonn
Scanner Manual Registration
Front ADF Registration
Flatbed Registration
Manually register the flatbed and ADF after replacing
the ADF, scanner glass, or controller board.
SSccaannnneerr CCoonnffiigguurraattiioonn
Edge Erase
Flatbed Edge Erase (3*)
ADF Edge Erase (3*)
Set the size, in millimeters, of the no-print area around
an ADF or flatbed scan job.
SSccaannnneerr CCoonnffiigguurraattiioonn
Disable Scanner
Enabled*
Disabled
ADF Disabled
Disable the scanner if it is not working properly.
SSccaannnneerr CCoonnffiigguurraattiioonn
Tiff Byte Order
CPU Endianness*
Little Endian
Set the byte order of a TIFF-formatted scan output.
Xerox
®
B305/B315 Multifunction Printer User Guide 141
Use printer menus