Using the e-mail setup wizard in the printer
Note: Before using the wizard, make sure that the printer firmware is updated. For more information, see
Updating Firmware.
1. From the home screen, touch EE--mmaaiill.
2. Touch SSeett uupp nnooww, and then type your e-mail address.
3. Type the password.
• Depending on your e-mail service provider, type your account password, app password, or authentication
password. For more information on the password, see the list of e-mail service providers, and then look for
Device Password.
• If your provider is not listed, then contact your provider and ask for the Primary SMTP Gateway, Primary
SMTP Gateway Port, Use SSL/TLS, and SMTP Server Authentication settings.
4. Touch OOKK.
Xerox
®
B305/B315 Multifunction Printer User Guide 53
Set up, Install, and Configure
To Next Page
Loading...
