7/98
Xerox DocuPrint P8e Service Manual 5-9 General Procedures and Information
5.3.1.2 Installing Status Monitor and Remote Control Panel
Installing the software for Windows 95/98
1 Insert the diskette labeled “Xerox DocuPrint P8e RCP and SM Disk” into your computer’s floppy
drive.
2 From the Start Menu, select Run.
3 Type A:\setup and press Enter. Follow the on-screen instructions to complete the installation.
Installing the software for Windows 3.1x
1 Insert the diskette labeled “Xerox DocuPrint P8e RCP and SM Disk” into your computer’s floppy
drive.
2 From the Program Manager, select File, Rum.
3 Type a:\setup and press Enter. Follow the on-screen instructions to complete the installation.
Installing software for Windows NT 4.0 (RCP only)
1 Insert the diskette labeled “Xerox DocuPrint P8e NT 4.0 Disk” into your computer’s floppy drive.
2 From the Start Menu, select Run.
3 Type A:\ntrcp\setup and press Enter. Follow the on-screen instructions to complete the
installation.
Installing software for DOS
1 Insert the diskette labeled “Xerox DocuPrint P8e RCP and SM Disk” into your computer's floppy
driver.
2 At the DOS prompt, enter the following commands:
> md dosrcp
> cd dosrcp
> copy a:\dosutil\*.*
> dosp8e.bat
5.3.2 Status Monitor
NOTE: The Status Monitor is not available with Windows NT 4.0.
The Status Monitor program runs in background mode. When selected, the Status Monitor automatically
displays messages from the printer on the computer screen whenever the printer's status changes.
NOTE: On some machines Window’s Print Manager must be disabled to get the Status Monitor to
operate correctly.
Status Monitor Messages
ON-LINE: The printer is in Ready Mode, online and is ready to receive print data. The printer may be in
standby mode or Power Save mode. When first turned on, the printer goes to this mode.
To Next Page
Loading...
Need help?
General