7/98
General Procedures and Information 5-20 Xerox DocuPrint P8e Service Manual
5.4.2.1 Status Mode
When the printer is powered on after connecting the DCU, the DCU automatically enters the Status
Mode. The Status Mode monitors the status of printer functions during normal operations. As each
function is executed, its Status/Error Code is displayed. If any function fails, the Status/Error Code for
that function is displayed until the problem or error has been corrected. (A list of codes and status/error
parameters is in Table 5.4.3 on the following page.)
If the problem is resolved without disconnecting power, Status Mode removes the error code displayed
and resumes normal operation.
If power is disconnected, powering on once again causes Status Mode to repeat its status review until
another problem is detected, or the review is successfully completed.
Whenever Status Mode no longer detects any problem, the displayed Status Code will be one of the
three Ready codes (00, 01, 02), depending on which paper size has been selected.
Status Mode can be interrupted only by disconnecting power to the printer.
To Next Page
Loading...
Need help?
General