Xerox DocuPrint P8EX Service Manual

3/99
Addendum 8-6 Xerox DocuPrint P8ex Service Manual
REP 4.6.3A Controller PWB (P8ex)
Removal
The printer has been upgraded to allow easy access to the Controller PWB. The Controller PWB is
accessed by removing two screws from the rear of the printer and pulling the board out of the printer.
Memory can be upgraded or the Controller PWB can be replaced.
Removing the Controller PWB
1 Turn off the printer and unplug the power cord.
2 Disconnect all cables from the rear of the printer.
3 Remove the two screws from the Controller PWB (Figure 2).
4 Pull the Controller PWB out of the printer (Figure 2).
Figure 2. Removing the Controller PWB
5 Disconnect J2 and J5 from the Controller PWB.
CAUTION
These components are susceptible
to electrostatic discharge. Observe
all ESD procedures to avoid
damage.
Video Controller PWB

Xerox DocuPrint P8EX Specifications

General

Brand	Xerox
Model	DocuPrint P8EX
Category	Printer
Language	English