Description of Menu Items
Phaser® 6180MFP Multifunction Printer
9-18
Maintenance
Use this menu to initialize the NVM, to configure security setting, or to adjust the
configurations for each type of paper.
■ Auto Regi Adjust: Adjusts the color registration automatically. Selecting On adjusts the
color registration automatically. The default is On.
■ Adjust ColorRegi: Correct the color registration manually. For details, refer to Color
Registration on page 10-25.
■ Auto Correct: Corrects the color registration automatically.
■ Color Regi Chart: Prints the correction chart.
■ Color Regi: Enter the number to correct the registration.
■ Initialize NVM: Initializes the settings stored in the NVM except for the network settings.
The NVM is a nonvolatile memory that stores the printer settings even after the power is
turned off. After executing this function and restarting the printer, all the menu parameters
are reset to their default values.
■ You cannot initialize the NVM during printing.
■ You need to restart the printer to activate this setting. After making the setting, turn off
the printer, and then turn it on again.
■ Init PrintMeter: Initializes the print meter.
■ Non-Xerox Toner: Specifies whether to use refilled print cartridges.
Caution: Non-Xerox toner may seriously damage the printer. Damage caused by Non-
Xerox toner may not be covered by your warranty.
Secure Settings
Use the Secure Settings menu to set a password to limit access to the menus.
■ Panel Lock: When enabled, access to the Admin Menu requires a password.
■ Scan/Fax Lock: When enabled, access to the scanner and fax requires a password. Panel
Lock must be enabled before enabling Scan/Fax Lock.
■ Secure Receive Lock: When enabled, incoming faxes require a password to print them.
Panel Lock must be enabled before enabling Secure Receive Lock.
To Next Page
Loading...
Need help?
General
