Xinje DS5F-43P0-PTA - Gain Adjustment; Load Shaking; Vibration; Noise

148
6.8 Gain adjustment
6.8.1 Load shaking
The following causes cause load wobble:
1. The instruction is not smooth enough when the load inertia is too large.
Countermeasure:
(1) Use position instruction smoothing filter P1-25;
(2) Optimizing the instructions of the upper device to reduce the acceleration of the instructions;
(3) Replace the motor with greater inertia.
2. Servo gain is too small, resulting in insufficient rigidity
Countermeasure:
(1) Increase the gain parameters and rigidity to enhance the anti-disturbance ability.
3. Insufficient rigidity of mechanism and equipment sloshing
Countermeasure:
(1) Reducing gain parameters;
(2) Optimize the instructions of the upper device and reduce the acceleration of the instructions.
6.8.2 Vibration
The following causes cause machine vibration:
(1) Vibration due to inappropriate servo gain
Countermeasure: Reduce gain
(2) Mechanical resonance point
Countermeasure: Setting notch parameters manually or through mechanical characteristic analysis
6.8.3 Noise
In adaptive mode:
(1) Inappropriate servo gain
Countermeasure: Reduce the adaptive control bandwidth (P2-19).
In auto-tuning mode:
(1) Inappropriate servo gain
Countermeasure: Under the mode of rapid adjustment, reduce the rigidity level.
Automatic Adjustment Mode: Reducing Model Loop Gain P2-49
(1) Noise due to mechanical resonance
Countermeasure: Refer to 6.8.2 vibration.