Need help?Do you have a question about the Xtralis ADPRO Presidium and is the answer not in the manual?
General| Brand | Xtralis |
|---|---|
| Model | ADPRO Presidium |
| Category | Security System |
| Language | English |
Emphasizes safety precautions for installation, configuration, and use.
Details liability limitations, including specific disclaimers for fitness for purpose.
Outlines installation requirements and warnings for safe operation.
Provides a caution regarding the internal lithium battery and its replacement.
Cautions that interface ports must connect only to Safety Extra Low Voltage (SELV) rated equipment.
Lists the key features and capabilities of the Presidium system.
Highlights the specific features of the Presidium Mini model.
Outlines the sequential steps required for installing a Presidium system.
Outlines the three key elements involved in the system design phase.
Details conducting a site survey to determine system requirements and design.
Covers system hardware, focusing on camera selection and location.
Discusses the importance of camera selection and placement for system operation.
Specifies CCIR/PAL or RS170/NTSC standards and signal voltage requirements.
Explains the criticality of correct horizontal FOV for reliable detection.
Details how FOV and target size determine camera and lens configuration.
Covers essential aspects of camera position and mounting for reliable performance.
Discusses using complementary technologies like PIR for enhanced system effectiveness.
Explains how to achieve optimal PIR placement angle for good performance.
Emphasizes camera alignment for perimeter coverage and avoiding blind spots.
Details ideal illumination practices and considerations for optimal camera performance.
Discusses backup power supply considerations for system reliability.
Instructs on installing the Presidium system according to practices and regulations.
Warns about potential interference and suggests design countermeasures.
Covers the phase of configuring and testing the installed system.
Details performing detection tests to ensure effective operation and limit nuisance alarms.
Guides on performing and documenting detection tests for system validation.
Covers five key areas of system maintenance and management.
Details routine maintenance procedures for the system and PIR detectors.
Recommends performing monthly detection tests to check for unauthorized intrusions.
Covers power connection requirements for Presidium and Presidium Mini.
Guides the user through unpacking and installing the setup utility.
Details the process of installing the Presidium Setup Utility software.
Guides on configuring PC network settings for connection to the Presidium.
Outlines the procedure for configuring the Presidium using the setup utility.
Explains how to establish a connection to the Presidium unit.
Guides on configuring detection areas and alarm behavior for each channel.
Details calibrating cameras to accurately determine target sizes.
Guides on defining detection and trigger areas to reduce false alarms.
Guides on adjusting detection sensitivity and environmental activity settings.
Explains how to set detection sensitivity levels for intrusion guarding.
Covers configuring alarm inputs, VMD behavior, and channel isolation.
Covers enabling alarms for video tampering or camera faults.
Guides on configuring static IP addresses for network connectivity.
Guides on setting up access/secure input types and authentication.
Details the process of upgrading the Presidium system software.
Provides guidance on troubleshooting common issues with the Presidium system.
Guides on checking various settings to resolve detection issues.
Explains how to retrieve a forgotten IP address using system information.
Offers solutions for connection issues, including IP subnet mismatches.
Details the procedure to reset a forgotten Presidium password.
Guides on troubleshooting HLI connection issues with FastTrace.
Explains how to resolve issues with starting the setup utility.
To Next Page
