YASKAWA DX200 - Signal off

Alarm List Alarm Number (4000 to 4999)
Alarm List-833
-44 Double chain error Software operation error
occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
-45 Media error (not fixed disk) Software operation error
occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
-50 ATA command incomplete Software operation error
occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
-51 Sector read command error Software operation error
occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
-52 Sector write command error Software operation error
occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
4626 IMPOSSIBLE S-AXIS
MOV (IN SPHERE)
Setting error (1)Check the following settings.
∙ Check the settings for the limit distance for S-axis rotation center
motion (S1CG067).
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4627 GUN RECOGNITION
SIGNAL OFF
Sub Code: Gun number Setting error (1)Check the following settings.
∙ Check the settings for the gun identification signal.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4628 WRITE VARIABLE
NO. MULTI SETTING
Sub Code: Duplicated
variable number
Setting error (1)Check the following settings.
∙ Check the settings for the written destination variable numbers.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy