YASKAWA DX200 - Preparation before Replacing Parts

4 Preparation before Replacing Parts
4-1
4 Preparation before Replacing Parts
WARNING
• Before operating the manipulator, check that the SERVO ON
lamp turns OFF when the emergency stop buttons on the front
door of the DX200 and the programming pendant are pressed.
Injury or damage to machinery may result if the manipulator cannot be
stopped in case of an emergency.
• Observe the following precautions when performing teaching
operations within the P-point maximum envelope of the
manipulator:
– Be sure to use a lockout device to the safeguarding when
going inside.
Also, display the sign that the operation is being performed
inside the safeguarding and make sure no one closes the
safeguarding.
– View the manipulator from the front whenever possible.
– Always follow the predetermined operating procedure.
– Keep in mind the emergency response measures against the
manipulator’s unexpected motion toward you.
– Ensure that you have a safe place to retreat in case of
emergency.
Improper or unintended manipulator operation may result in injury.
• Confirm that no persons are present in the P-point maximum
envelope of the manipulator and that you are in a safe location
before:
– Turning ON the DX200 power.
– Moving the manipulator with the programming pendant
Injury may result if anyone enters the P-point maximum envelope of the
manipulator during operation.Always press the emergency stop button
immediately if there are problems.
Emergency stop buttons are located at the upper right corner of the
front door of the DX200 and on the upper right of the programming
pendant.