YASKAWA DX200 - Over-Current

Alarm List Alarm Number (4000 to 4999)
Alarm List-611
4 Error from welder 4. Arc welding power source
error
When finish system reset, Shut down the welding power source.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
5 Error from welder 5. Arc welding power source
error
When finish system reset, Shut down the welding power source.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
6 Error from welder 6. Arc welding power source
error
When finish system reset, Shut down the welding power source.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
7 Error from welder 7. Arc welding power source
error
When finish system reset, Shut down the welding power source.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
8 Error from welder 8. Arc welding power source
error
When finish system reset, Shut down the welding power source.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
302 Sub code: Error No. from
welder.
Arc welding power source
error
When finish system reset, Shut down the welding power source.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4242 MOTOWELD INPUT
OVER-CURRENT
1 Error from welder 1. Arc welding power source
error
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy