Alarm List
Alarm Number (4000 to 4999)
Alarm List-839
11 Welding command process
exceptional error
Software operation error
occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
102 The specified welder number
(system) could not be found.
Setting error (1)Check the following setting.
∙ Confirm the specified welder number (system) and the setting.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4645 NOT PERMIT FIXED-
WEAV ON SWVON
Setting error (1)Check the following setting.
∙ Check the settings for jobs.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4648 FILE TRANSFER
ERROR (ARITH)
1 Motion range file transfer error Setting error (1)Check the following setting.
∙ Check if the motion range file is correctly set.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
2 Part motion range file transfer
error
Setting error (1)Check the following setting.
∙ Check if the part motion range is correctly set.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4649 PARTIAL MOTION
RANGE INTRF.
Sub Code: Interference
control group number &
interference axis &
interference area number.
Setting error (1)Check the following setting.
∙ Check the setting of the teaching position of the manipulator.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy
To Next Page
Loading...
