EasyManua.ls Logo

YASKAWA DX200 - Page 1117

YASKAWA DX200
1166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Alarm List
Alarm Number (4000 to 4999)
Alarm List-896
Other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4 Safety signal board alloc
information transmission error
was detected.
Setting error (1) Please display the screen of the "safety function" - "safe logic
circuit", and check the value of a "signal", "logic", and a "timer."
When a value is inaccurate, please set up the right value and perform
"writing."
Other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
253 M-safety command reception
time out was detected.
Setting error (1) Please display the screen of the "safety function" - "safe logic
circuit", and check the value of a "signal", "logic", and a "timer."
When a value is inaccurate, please set up the right value and perform
"writing."
Other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
254 Safe logic circuit information
write error was detected.
Setting error (1) Please display the screen of the "safety function" - "safe logic
circuit", and check the value of a "signal", "logic", and a "timer."
When a value is inaccurate, please set up the right value and perform
"writing."
Other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
255 Safe logic circuit information
cancel error was detected.
Setting error (1) Please display the screen of the "safety function" - "safe logic
circuit", and check the value of a "signal", "logic", and a "timer."
When a value is inaccurate, please set up the right value and perform
"writing."
Other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy

Table of Contents

Other manuals for YASKAWA DX200

Related product manuals