YASKAWA DX200 - Page 156

9Error
9.1 Error Message
9-20
8213 - Check EXTERNAL IO setup
8216 - Cannot change setting. Check
the setting of control group.
Invalid the settings of the high speed spot welding or
re-examine the control group configuration by
referring to “Chapter 9.13. High Spot Welding
Function” in “DX200 OPERATOR’S MANUAL FOR
SPOT WELDING USING MOTOR GUN” (Manual
No.RE-CSO-A046).
8217 - Cannot change setting. Check
the setting of spot high speed
spec.
Invalid the settings of the high speed spot welding or
re-examine the control group configuration by
referring to “Chapter 9.123 High Spot Welding
Function” in “DX200 OPERATOR’S MANUAL FOR
SPOT WELDING USING MOTOR GUN” (Manual
No.RE-CSO-A046).
8250 - Setting group is duplicated that
has been set in the axes
detachment function.
8251 - Setting group is duplicated that
has been set in the robot
detachment function.
Error No. Data Error Message Contents