YASKAWA DX200 - Page 168

10 Job Data Simplified Restoration Function
10.2 Job Data Restoration
10-8
– The indication changes from “OCCURRED ON” to “REGISTERED
ON”.
* If fail in the restoration
– If the indication doesn’t change from “OCCURRED ON” to
“RESTORED ON”, refer to chapter 10.3 “If Fail in Simplified
Restoration” at page 10-12.
2. Start up the system again
– After the restoration, the system must be started up again.
Turn the control power OFF/ON and then execute the following
checking operation.
3. Press {SETUP} under main menu and select {WRONG DATA LOG}