3 Inspections
3.2 DX200 Inspections
3-2
3.2 DX200 Inspections
3.2.1 Checking if the Doors are Firmly Closed
• The DX200 has a fully sealed construction, designed to keep exter-
nal air containing oil mist out of the DX200.
Be sure to keep the DX200 doors fully closed at all times, even when
the controller is not operating.
• When opening or closing the doors for maintenance, use the screw-
driver after the main power is turned OFF. (CW: Open, CCW: Close)
Make sure to push the door and turn the door-lock with the driver to
open or close the door. When closing the door, turn the door lock
until it clicks.
Fig. 3-1: DX200 Front View
3.2.2 Checking for Gaps or Damage in the Sealed Construction Section
• Open the door and check that the seal around the door is undam-
aged.
• Check that the inside of the DX200 is not stained badly. If it is, deter-
mine the cause, take measures and immediately clean it.
• Firmly lock each door and check that no excessive gaps exist around
the edge of the door.
Primary Power
Supply Cable
Main power switch
Door lock
Door lock
To Next Page
Loading...
