YASKAWA DX200 - Page 368

Alarm List Alarm Number (0000 to 0999)
Alarm List-161
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
41 In the output side setting of
allocation configuration data,
some of the TOYOPUC’s R-
registers are specified
redundantly.
Setting error (1)Check the following settings.
∙ Allocation configuration for the TOYOPUC
Connection failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, check the connection and insertion of the
following connector.
∙ The PCI connector of the TOYOPUC board
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
42 In the output side setting of
allocation configuration data,
some of the M-registers of
concurrent I/O are specified
redundantly.
Setting error (1)Check the following settings.
∙ Allocation configuration for the TOYOPUC
Connection failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, check the connection and insertion of the
following connector.
∙ The PCI connector of the TOYOPUC board
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
44 In the input side setting of
allocation configuration data,
some of the TOYOPUC’s R-
registers are specified
redundantly.
Setting error (1)Check the following settings.
∙ Allocation configuration for the TOYOPUC
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy