YASKAWA DX200 - Page 443

Alarm List Alarm Number (1000 to 1999)
Alarm List-236
47 Linear servo float condition file Data error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, initialize the appropriate data in
maintenance mode, and then load the data saved in the external
memory device.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
48 Macro definition file Data error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, initialize the appropriate data in
maintenance mode, and then load the data saved in the external
memory device.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
49 Seal amount correction
condition file (spray)
Data error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, initialize the appropriate data in
maintenance mode, and then load the data saved in the external
memory device.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
50 Seal amount correction
condition file (undercoat)
Data error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, initialize the appropriate data in
maintenance mode, and then load the data saved in the external
memory device.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
51 Arc monitor file Data error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, initialize the appropriate data in
maintenance mode, and then load the data saved in the external
memory device.
Alarm
Number
Alarm Name Sub
Code
Meaning Cause Remedy