YASKAWA DX200 - Page 497

Alarm List Alarm Number (1000 to 1999)
Alarm List-290
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
66 An error occurred in the
Ethernet function DNS
domain getting process in the
DHCP of the Ethernet
function.
Setting error (1)Check the following settings.
∙ The DHCP server operation
∙ The network status
YCP21 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP21 board. Save the
CMOS.BIN before replace the board to be safe. Replace the YCP21
board, and then remove the CF from the failure YCP21 board to insert
it into the new YCP21 board.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
67 An error occurred in the SNTP
server address acquisition
process in the DHCP of the
Ethernet function.
Setting error (1)Check the following settings.
∙ The DHCP server operation
∙ The network status
YCP21 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP21 board. Save the
CMOS.BIN before replace the board to be safe. Replace the YCP21
board, and then remove the CF from the failure YCP21 board to insert
it into the new YCP21 board.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
68 An error occurred in the IP
address acquisition process in
the DHCP of the Ethernet
function.
Setting error (1)Check the following settings.
∙ The DHCP server operation
∙ The network status
Alarm
Number
Alarm Name Sub
Code
Meaning Cause Remedy