v
Definition of Terms Used Often in This Manual
The MOTOMAN manipulator is the YASKAWA industrial robot product.
The MOTOMAN usually consists of the controller, the programming
pendant, and supply cables.
In this manual, the equipment is designated as follows.
• Perform the following inspection procedures prior to
conducting manipulator teaching. If problems are found,
repair them immediately, and be sure that all other necessary
processing has been performed.
-Check for problems in manipulator movement.
-Check for damage to insulation and sheathing of external
wires.
• Always return the programming pendant to the hook on the
DX200 cabinet after use.
The programming pendant can be damaged if it is left in the P-point
maximum envelope of the manipulator, on the floor, or near fixtures.
• Read and understand the Explanation of Warning Labels in the
DX200 Instructions before operating the manipulator.
Equipment Manual Designation
DX200 Controller DX200
DX200 Programming Pendant Programming Pendant
Cable between the manipulator and the
controller
Manipulator cable
To Next Page
Loading...
