Alarm List
Alarm Number (4000 to 4999)
Alarm List-452
10 Separate group axis being
used
Setting error (1)Reset the alarm.
(2)Check the following setting.
∙ I/O jog executing status
Complete the I/O jog executing status, and then restart.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
11 The servo power supply is
OFF.
Setting error (1)Reset the alarm.
(2)Check the following setting.
∙ Servo power
Turn ON servo power.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
12 Twin synchronous task ID
error
Setting error (1)Reset the alarm.
(2)Check the following setting.
∙ Twin synchronous task specification of SYNC instruction
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
16 PSTART instruction is the old
specification.
Setting error (1)Reset the alarm.
(2)Check the following settings.
∙ The specifications of PSTART instruction
Register the PSTART instruction as new specification.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
17 PWAIT instruction is the old
specification.
Setting error (1)Reset the alarm.
(2)Check the following settings.
∙ The specifications of PWAIT instruction
Register the PWAIT instruction as new specification.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy
To Next Page
Loading...
