Alarm List
Alarm Number (4000 to 4999)
Alarm List-593
11 An error occurred in the
setting clearing process to
update DNS information in the
DNS process of the Ethernet
function.
Setting error (1)Check the following settings.
∙ The DHCP server operation (If the DHCP is used)
∙ The network status (If the DHCP is used)
YCP21 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP21 board. Save the
CMOS.BIN before replace the board to be safe. Replace the YCP21
board, and then insert the CF card which inserted original YCP21
board into the new YCP21 board.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
20 The subnet mask was not
able to be acquired in the
DHCP information update
process of the Ethernet
function.
Setting error (1)Check the following settings.
∙ The DHCP server operation (If the DHCP is used)
∙ The network status (If the DHCP is used)
YCP21 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP21 board. Save the
CMOS.BIN before replace the board to be safe. Replace the YCP21
board, and then insert the CF card which inserted original YCP21
board into the new YCP21 board.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
21 Subnet mask update error
occurred in the DHCP
information update process of
the Ethernet function.
Setting error (1)Check the following settings.
∙ The DHCP server operation (If the DHCP is used)
∙ The network status (If the DHCP is used)
YCP21 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP21 board. Save the
CMOS.BIN before replace the board to be safe. Replace the YCP21
board, and then insert the CF card which inserted original YCP21
board into the new YCP21 board.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy