YASKAWA DX200 - Page 858

Alarm List Alarm Number (4000 to 4999)
Alarm List-637
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
6 Error from welder 6. Arc welding power source
error
Check if the wire load becomes heavy. Make sure that the torch cable
and conduit cable are not bent excessively.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
7 Error from welder 7. Arc welding power source
error
Check if the wire load becomes heavy. Make sure that the torch cable
and conduit cable are not bent excessively.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
8 Error from welder 8. Arc welding power source
error
Check if the wire load becomes heavy. Make sure that the torch cable
and conduit cable are not bent excessively.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
502 Sub code: Error No. from
welder.
Arc welding power source
error
Check if the wire load becomes heavy. Make sure that the torch cable
and conduit cable are not bent excessively.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4260 MOTOWELD CPU
ERROR1
1 Error from welder 1. Arc welding power source
error
The board may be broken. Contact your Yaskawa representative.
2 Error from welder 2. Arc welding power source
error
The board may be broken. Contact your Yaskawa representative.
3 Error from welder 3. Arc welding power source
error
The board may be broken. Contact your Yaskawa representative.
4 Error from welder 4. Arc welding power source
error
The board may be broken. Contact your Yaskawa representative.
5 Error from welder 5. Arc welding power source
error
The board may be broken. Contact your Yaskawa representative.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy