YASKAWA DX200 - Page 870

Alarm List Alarm Number (4000 to 4999)
Alarm List-649
7 Error from welder 7. Arc welding power source
error
The data may not have been correctly saved when the welding
conditions are recorded because of a power failure, etc. Reset the
system after saving the changed parameters. (See the manual of
MOTOWELD "4.2.10 System Reset")
If the error occurs again, the board may be broken. Contact your
Yaskawa representative.
8 Error from welder 8. Arc welding power source
error
The data may not have been correctly saved when the welding
conditions are recorded because of a power failure, etc. Reset the
system after saving the changed parameters. (See the manual of
MOTOWELD "4.2.10 System Reset")
If the error occurs again, the board may be broken. Contact your
Yaskawa representative.
209 Sub code: Error No. from
welder.
Arc welding power source
error
The data may not have been correctly saved when the welding
conditions are recorded because of a power failure, etc. Reset the
system after saving the changed parameters. (See the manual of
MOTOWELD "4.2.10 System Reset")
If the error occurs again, the board may be broken. Contact your
Yaskawa representative.
4268 MOTOWELD
MEMORY ERROR7
1 Error from welder 1. Arc welding power source
error
The data may not have been correctly saved when the welding
conditions are recorded because of a power failure, etc. Reset the
system after saving the changed parameters. (See the manual of
MOTOWELD "4.2.10 System Reset")
If the error occurs again, the board may be broken. Contact your
Yaskawa representative.
2 Error from welder 2. Arc welding power source
error
The data may not have been correctly saved when the welding
conditions are recorded because of a power failure, etc. Reset the
system after saving the changed parameters. (See the manual of
MOTOWELD "4.2.10 System Reset")
If the error occurs again, the board may be broken. Contact your
Yaskawa representative.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy