YASKAWA DX200 - Page 989

Alarm List Alarm Number (4000 to 4999)
Alarm List-768
11 The incorrect coordinate
system is designated for the
cubic interference. An
undefined coordinate system
is set.
Setting error (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
12 The designation of the user
coordinates number is
incorrect. A number out of the
setting range is set.
Setting error (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
13 The reduction ratio <= 0 is
output.
Setting error (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
14 Zero or a negative value is set
for the spring constant.
Setting error (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
15 Zero or a negative value is set
for the motor inertia.
Setting error (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
16 Zero or a negative value is set
for the speed calculation
constant.
Setting error (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
17 Dividing number setting error Setting error (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
18 The setting of allowable
torque for the speed reducer
is incorrect.
Setting error (1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy