Administrator’s Guide for SIP-T46G IP Phone
106
same VoIP codec as your voice and is audible to the conversation partners.
SIP INFO
DTMF digits are transmitted by the SIP INFO messages when the voice stream is
established after a successful SIP 200 OK-ACK message sequence. The SIP INFO
message is sent along the signaling path of the call. The SIP INFO message can support
transmitting DTMF digits in three ways: DTMF, DTMF-Relay and Telephone-Event.
Procedure
Configuration changes can be performed using the configuration files or locally.
Configure the method of
transmitting DTMF digit and the
payload type.
For more information, refer to
DTMF on page 287.
Configure the number of times
for the IP phone to send the end
RTP Event packet.
For more information, refer to
DTMF on page 287.
Configure the method of
transmitting DTMF digits and
the payload type.
Navigate to:
http://<phoneIPAddress>/servl
et?p=account-adv&q=load&ac
c=0
Configure the number of times
for the IP phone to send the end
RTP Event packet.
Navigate to:
http://<phoneIPAddress>/servl
et?p=features-general&q=loa
d
To configure the method of transmitting DTMF digits via web user interface:
1. Click on Account.
2. Select the desired account from the pull-down list of Account.
3. Click on Advanced.
4. Select the desired value from the pull-down list of DTMF Type.