Configuring Basic Features
81
Procedure
Call hold can be configured using the configuration files or locally.
Configure the call hold tone and
call hold tone delay.
Specify whether RFC 2543
(c=0.0.0.0) outgoing hold
signaling is used.
For more information, refer to Call
Hold on page 268.
Configure the call hold tone and
call hold tone delay.
Specify whether RFC 2543
(c=0.0.0.0) outgoing hold
signaling is used.
Navigate to:
http://<phoneIPAddress>/servlet
?p=features-general&q=load
To configure the call hold method via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of RFC 2543 Hold.
3. Click Confirm to accept the change.
To configure the call hold tone and call hold tone delay via web user interface:
1. Click on Features->General Information.