Configuring Advanced Features
157
The supported LLDP-MED TLV types are:
LLDP-MED Capabilities, Network Policy,
Extended Power via MDI-PD, Inventory.
Port VLAN ID, application type, L2 priority
and DSCP value.
Power type, source, priority and value.
Inventory –
Hardware Revision
Hardware revision of phone.
Inventory –
Firmware Revision
Firmware revision of phone.
Inventory –
Software Revision
Software revision of phone.
Inventory – Serial
Number
Inventory –
Manufacturer Name
Manufacturer name of phone.
The default value is ―yealink‖.
Assertion identifier of phone.
The default value is ―asset‖.
Procedure
LLDP can be configured using the configuration files or locally.
Configure the LLDP feature.
For more information, refer to
LLDP on page 311.
Configure the LLDP feature.
Navigate to:
http://<phoneIPAddress>/servl
et?p=network-adv&q=load
To configure LLDP via web user interface:
1. Click on Network->Advanced.
2. In the LLDP block, select the desired value from the pull-down list of Active.
3. Enter the desired time interval in the Packet_Interval (1~3600s) field.