Yeastar Technology TG200 - Set up Mobile to IP Route (Register Trunk Mode); PBX Integration - Register Trunk Routing

TG Series User Guide
34/86
3. Check the trunk status on TG gateway Status > System Status > Trunk Status.
If the trunk status shows , then the TG gateway and your PBX are connected.
Set up a Mobile to IP Route (Register Trunk Mode)
Procedure
1. Navigate to Gateway > Routes Settings > Mobile to IP.
2. Click Add Mobile to IP Route.
3. Enter a name in the Route Name field.
4. Choose a GSM/3G trunk or a trunk group from Call Source field.
5. Choose a register SIP trunk from the Call Destination field.
6. (Optional) Set the Hotline number.
 If you set hotline to a PBX extension number, the incoming call will be routed to the
extension directly.
Note: if you don’t set a hotline number, you will need a two-stage dial to reach the destination
number.