Yeastar Technology TG200 - Network and VoLTE Settings; Configure Network Type and Band

TG Series User Guide
26/86
6. (Optional) Enable E-mail notification and enter the email address to receive alarm e-mail.
7. Click Save and Apply Changes.
Configure Network Type and Band
By default, TG gateway identifies the SIM card network type and band automatically. If the network
type and band are not suitable for you, you can change the settings manually.
Procedure
1. Navigate to Gateway > Mobile List > Mobile List, select the desired module, click .
2. Click the Advanced Settings tab.
3. Choose a Network Type, the system will use the selected network type to make and receive calls.
4. Set Band to Manual, and select the desired band.
5. Click Save and wait for the web page reloading for about 1 minute, then click Apply Changes.