• Setup Menu Operations (Same as soft key operations)
Selecting a Setup Menu Item
Click the setup menu item that you want to select.
If a selection menu appears after you select an item, click the selection menu item that you want
to choose.
If an item such as ON or OFF appears, click on the item to change its setting.
For menu items that are usually selected using the job shuttle and the SET
key, clicking on the
item that you want to select will confirm your selection and close the dialog box.
Click in this area to display a selection menu.
Clicking the selection menu item that you want to select will
confirm your selection.
Click in this area to display a menu for selecting items using the
jog shuttle and SET.
Clicking the menu item that you want to select will confirm your
selection.
Click in this area to change the selected item.
Clearing the Menu
To clear the menu, click outside of it.
• Specifying Values
The following description explains how to specify values for menu items that have a
icon next
to them.
• If there are two
icons next to a single menu item, click on the item to select an item to
configure.
• T
o increase a value, rotate the mouse wheel back.
• To decrease a value, rotate the mouse wheel forward.
• To increase a value, move the pointer above the value so that the pointer becomes a
, and
then click the left mouse button.
• T
o decrease a value, move the pointer below the value so that the pointer becomes a
, and
then click the left mouse button.
• T
o move the decimal place, point to the left or right of the value you want to set so that the
pointer becomes a
or a , and then click the left mouse button. The decimal place will
move one place to the right or left each time you click the left mouse button.
Click within this area to select the item that you want to set.
Change the value by clicking and using the mouse wheel.
4.3 Using USB Keyboards and Mouse Devices
To Next Page
Loading...
Need help?
General
