How to Use This Manual
Content Summary
This user’s manual consists of the chapters listed below. For information about the
communication features and the accompanying software DAQSTANDARD, read the
respective manual.
Chapter Title and Contents
1 Feature Overview
The MV features.
2 Installation and Wi
ring
How to install the MV, how to wire input terminals, and how to connect the power
cable.
3 Measurement Channels and Alarms
How to set measurement conditions and how to set alarms.
4 Measurement and Record
ing
How to record and store measured values and other values. This chapter also
explains how to load measured data or setup data from a CF card or USB flash
memory.
5 Screen Operations
How to use the operation screen.
6 D
i
splay Conf
iguration
How to change the displayed information on the operation screen and how to write
a message.
7 Event
Act
i
on
How to make the MV perform a specific action in response to an event, a remote
control signal input, or a pressing of the USER key.
8 Security Features
How to use the key lock feature and the feature that allows only registered users to
operate the MV
.
9 Env
i
ronment Sett
ings
How to configure the time settings and how to operate the MV by using a keyboard.
10 Computat
i
on and Report Funct
ions (/M1 and /PM1 options)
How to use computation channels and how to create various reports, such as
hourly, daily, weekly, and monthly reports.
11 External Input Channels (/MC1 opt
i
on)
How to use external input channels.
12
Troubleshooti
ng and Maintenance
Explains error messages and troubleshooting measures.
13 Spec
i
f
ications
Lists the MV specifications.
Appendix D
escribes measured data file sizes, text file formats, etc.
Index
Note
• This user’s manual covers information about MVs that have a suffix code for language “-2”
(English).
• For language configuration instructions, see section 9.4, “Changing the Language.”
To Next Page
Loading...
Need help?
General
