3-30 IM 760301-01E
Moves the cursor upward.
Moves the cursor downward.
Switches between upper case and lower case.
Deletes the character before the entry position.
Switches between insert and overwrite mode.
Recalls the temporarily stored string.
Enters the string.
• Entering the Unit, File Name, and Comment
(the server name, user name, password, and e-mail address, etc. for Ethernet
communication)
The figure below shows the keyboard that appears when entering the file name or
comment. File names and comments can be temporarily held in the internal memory
so that they can be used in other file names and comments.
• Entering the File Name and Comment and Temporarily Storing Them
1. Press the
and cursor keys to select the desired character. You can move
the cursor quickly by holding down or to make the cursor skip. You can
also press the
and soft keys to move the cursor vertically.
2. Press SET to enter characters in the entry box.
If there are characters already in the entry box, use the
and cursor keys to
select the entry position.
3. Repeat steps 1 and 2 to enter all the characters.
4. After entering all the characters, select ENT on the keyboard and press SET.
The string is confirmed and the keyboard disappears (you can also press the
ENT key to achieve the same result). At the same time, the confirmed string is
temporarily stored in the internal memory.
Up to 8 sets of strings can be stored. After eight strings have been stored, a new string
overwrites the oldest string.
• Recalling the Temporarily Stored String
1. Press the soft key. Each time the soft key is pressed the temporarily stored
strings are displayed in the entry box of the keyboard in order. When the eight
strings that are temporarily stored are displayed, the most recent string is
displayed again.
If there are characters already in the entry box, they are overwritten with the recalled string.
2. Correct the recalled equation according to steps 1 to 4 in “Entering the File
Name and Comment and Temporarily Storing Them” described above and enter
it. The string is temporarily stored in the internal memory.
Entry box
Moves the cursor upward.
Moves the cursor downward.
Switches between upper case and lower case.
Deletes the character before the entry position.
Switches between insert and overwrite mode.
Recalls the temporarily stored string.
Enters the string.
3.14 Entering Values and Character Strings
To Next Page
Loading...
