YOKOGAWA wt3000 - Setting the Measurement Period

4-19
IM 760301-01E
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
Measurement Conditions
4.7 Setting the Measurement Period
Procedure
SENSOR RATIO
MEASURING
RMS MEAN DC RMEAN
CURRENT RANGEVOLTAGE RANGE
MEASURING
RMS MEAN DC RMEAN
ALL
INPUT INFO.
2
34
COMPEN
ELEMENT
ELEMENT
1
WIRING
MODE AUTO MODE AUTO
EXT SENSOR
To exit the menu during
operation, press ESC
located above the soft
keys.
In the procedural
explanation below, the
phrase “press the cursor
keys” may be used. This
phrase refers to the
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14.
START STOP
REMOTE
CAL
MOTOR
SET
CURSOR NULL
LOWER ITEM LOWER FORM ALL
USER SET
DISPLAY ITEM & ELEMENT
RESET SET
PAGE PAGE
SCALING
HRM SET MEASURE SYNC SOURCE
AVG LINE FILTER
FREQ
FILTER
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
Cursor keys
1. Press SYNC SOURCE to display the Sync Src menu.
• Selecting the Target Element
2. Press ELEMENT to select the target element. The selected element is displayed
in the upper right corner of the screen (if you selected element 1, Sync Src1 are
displayed). To select all elements, press SHIFT+ELEMENT (ALL).
• Setting the Synchronization Source
3. Press the Item Up Exec or Item Down Exec soft key to set the synchronization
source. The specified synchronization source is displayed by the element
displayed in the upper right corner of the screen.