3-26 IM 760301-01E
3.13 Initializing the Settings
Procedure
START STOP
REMOTE
CAL
MOTOR
SET
CURSOR NULL
MENU STORE SET
MENU
LOWER ITEM LOWER FORM ALL
USER SET
DISPLAY
ITEM & ELEMENT
RESET SET
PAGE PAGE
SCALING
HRM SET
MEASURE
SYNC SOURCE
AVG
LINE FILTER
FREQ
FILTER
FILE
PRINT
MISC
STORE
IMAGE SAVE
HELP
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
To exit the menu during operation, press ESC located above
the soft keys.
In the procedural explanation below, the phrase “press the
cursor keys” may be used. This phrase refers to the
procedures for selecting items and entering values and
character strings. For details on the procedures, see section
3.14.
Cursor keys
Note
Check that it is okay to initialize the settings before actually initializing the settings. You
cannot set the settings back after initialization. It is recommended that the setup parameters
be saved (see section 9.3) before initialization.
1. Press MISC to display the Misc menu.
2. Press the Initialize Settings soft key. An Alert dialog box appears.
3. Press the cursor keys to select OK.
4. Press SET to execute the initialization.
To cancel the initialization, select Cancel in step 3 and press SET.
To Next Page
Loading...
Need help?
General
