10-3
IM WT5000-02EN
10.2 Single Measurement
► “Single Measurement (Single Execute, SINGLE)” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Menu Icons (see page iii)
• Procedure Using the Keys (other than SETUP) (see section 1.2 in IM WT5000-03EN)
Procedure Using the Menu Icons
1.
Tap the Misc menu icon . A Misc menu appears in the sub menu area on the right side of
the screen.
2.
Tap the Hold ON/OFF button to select ON. The HOLD key illuminates, and the displayed
measured value is held.
3.
Tap Execute under Single. A single measurement is performed at the specified data update
rate, and the instrument then holds the measured value.
1. Execute the holding of measured values (OFF, ON)
When holding is in progress, the HOLD key illuminates.
2. Execute a single measurement.
You can execute this once while holding is in progress.
Note
If, while the HOLD key is illuminated, you tap Hold again, the HOLD key will turn off, and the held measured
values will be released. If you tap Single Execute while the hold feature is released, the measured value is
updated (re-measured) when the time specified by the data update rate elapses after you tap the key.
To Next Page
Loading...
