8-6
IM WT5000-02EN
8.3 Setting the Numeric Data Items to Save
► “Saved Numeric Items (Saved Numeric Items)” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
• Procedure Using the Menu Icons (see page iii)
• Procedure Using the Keys (other than SETUP) (see section 1.2 in IM WT5000-03EN)
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
2.
Tap Computation/Output tab. A computation and output settings overview screen appears.
Pressing ES
C
closes the overview screen.
Setting the Save Conditions (Data Save)
3.
Tap Data Save.
An save condition setup screen appears.
Computation/Output tab
Set the save conditions.
Numeric data item setup screen
Select how to set the numeric data items to
be saved.
(Displayed Numeric Items
1
, Selected Items
2
)
1 The numeric data items shown on the screen are saved.
2 The selected numeric data items are saved.
Select the numeric data items.
You can set this when Item is set to Selected Items.
Note
You can also display the computation/output settings overview screen by moving the cursor on the
Computation/Output tab using the arrow keys and then pressing SET.
To Next Page
Loading...
Need help?
General
