YOKOGAWA WT5000 User Manual

2-15
IM WT5000-02EN
2.5 Setting the Valid Measurement Range
► “Range Configuration (Range Config)” in the features guide
► “Valid Measurement Range (Valid Measurement Range)” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
This section explains how to set the measurement range when the crest factor (see section 2.9) is set
to CF3. When the crest factor is CF6 or CF6A, set the valid measurement ranges from the available
options.
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
2.
Tap the Input (Advanced/Options) tab. An input settings (advanced/options) overview screen
appears.
Pressing ESC closes the overview screen.
3.
Tap Range Config. A measurement range configuration setup screen appears.
Input (Advanced/Options) tab
Range Config button
Set the valid voltage measurement range.
Set the valid current measurement range.
Note
You can also display the input settings (advanced/options) overview screen by moving the cursor on the
Input (Advanced/Options) tab using the arrow keys and then pressing SET.

YOKOGAWA WT5000 Specifications

General

Frequency Range	DC, 0.1 Hz to 1 MHz
Number of Channels	Up to 7
Interfaces	USB, Ethernet, GP-IB, RS232
Sampling Rate	10 MS/s
Harmonic Analysis	Up to the 500th order
Weight	Approximately 15 kg
Display	10.1-inch WXGA (1280 x 800) TFT LCD