YOKOGAWA WT5000 - 2.3 Configuring the Current Sensor

2-9
IM WT5000-02EN
2.3 Configuring the Current Sensor
► “External Current Sensor On/Off (Ext Sensor)” in the features guide
► “External Current Sensor Conversion Ratio (Sensor Ratio)” in the features guide
► “Display Format of Current Range (Current Range Display Format)” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
• Procedure Using the Menu Icons (see page iii)
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP. 2. Tap the Input (Basic) tab. An input
settings (basic measurement conditions) overview screen appears.
Pressing ESC closes the overview screen.
Input (Basic) tab
Set the current range.
Note
You can also display the input settings (basic measurement conditions) overview screen by moving the
cursor on the Input (Basic) tab using the arrow keys and then pressing SET.