7-6
IM WT5000-02EN
7.2 Setting Stored Items
► “Stored Items” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
• Procedure Using the Menu Icons (see page iii)
• Procedure Using the Keys (other than SETUP) (see section 1.2 in IM WT5000-03EN)
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
2.
Tap Computation/Output tab. A computation and output settings overview screen appears.
Pressing ESC closes the overview screen.
Configuring the Storage (Store)
3.
Tap Store.
A storage setup screen appears.
Computation/Output tab
Configure the storage.
Select how to set the numeric
data items to be stored.
(Selected Items
1
)
1 The selected numeric data items are stored.
Select the storage time.
(Store, Measure)
Select the numeric data
items.
You can set this when Item is
set to Selected Items.
Note
You can also display the computation/output settings overview screen by moving the cursor on the
Computation/Output tab using the arrow keys and then pressing SET.
To Next Page
Loading...
