YOKOGAWA WT5000 - 2.7 Setting the Line Filter and Frequency Filter

2-21
IM WT5000-02EN
2.7 Setting the Line Filter and Frequency Filter
► “Line Filter (Line Filter)” in the features guide
► “Frequency Filter, Rectifier, Level (Freq Filter/Rectifier/Level)” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
• Procedure Using the Menu Icons (see page iii)
Depending on the measurement mode or the method of computing measurement values (computing
method), the settings may be different from the description in this section, the settings may be invalid,
or the settings may not be configurable. For details, see the features guide.
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
Setting the Line Filter and Frequency Filter (Cutoff)
2.
Tap the Input (Basic) tab. An input settings (basic measurement conditions) overview screen
appears.
Pressing ESC closes the overview screen.
Input (Basic) tab
Set the line filter. Set the frequency filter.
Note
You can also display the input settings (basic measurement conditions) overview screen by moving the
cursor on the Input (Basic) tab using the arrow keys and then pressing SET.
Setting the Line Filter (Line Filter)
3.
Tap
Line Filter
. A line filter setup screen appears.
Line filter (example of element 1)
Turns the line filter on or off
Set the cutoff frequency of the line filter
(0.1 kHz to 100.0 kHz (0.1 kHz steps), 1 MHz).