YOKOGAWA WT5000 - 2.4 Setting the Voltage Transformer (VT) and Current Transformer (CT) Ratios

2-13
IM WT5000-02EN
2.4 Setting the Voltage Transformer (VT) and
Current Transformer (CT) Ratios
► “Scaling (Scaling)” in the features guide
This section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
2.
Tap the Input (Basic) tab. An input settings (basic measurement conditions) overview screen
appears.
Pressing ESC closes the overview screen.
Input (Basic) tab
Set the VT ratio, CT ratio, and power coefficient.
Note
You can also display the input settings (basic measurement conditions) overview screen by moving the
cursor on the Input (Basic) tab using the arrow keys and then pressing SET.