YOKOGAWA WT5000 User Manual

12-3
IM WT5000-02EN
12.2 Cursor Measurement on Trends
This instrument shows on the screen the trends of the voltage and current applied to the input
elements or wiring units. When you place cursors on the trends, the instrument shows the measured
values at the cursor positions.
► “Cursor Measurement (Cursors)” in the features guide
Using an example, this section explains how to display trend cursor measurement results.
In addition, this section explains operating procedures using the following setup methods.
• Procedure Using the Setup Menu (see chapter 1)
• Procedure Using the Menu Icons (see page iii)
Cursor Measurement on Trends (Example of voltage and current)
Trend display of input element 1
Voltage trend
Current trend
Cursor C1 (+) on the voltage trend
Cursor C2 (×) on the current trend
Cursor measurement items
Procedure Using the Setup Menu
1.
Tap the Setup icon , or press MENU under SETUP.
2.
Tap Computation/Output tab. A computation and output settings overview screen appears.
Pressing ESC closes the overview screen.
3.
Tap Display.
A display format setup screen (Numeric/Graph) appears. For details, see section 6.1.

YOKOGAWA WT5000 Specifications

General

Frequency Range	DC, 0.1 Hz to 1 MHz
Number of Channels	Up to 7
Interfaces	USB, Ethernet, GP-IB, RS232
Sampling Rate	10 MS/s
Harmonic Analysis	Up to the 500th order
Weight	Approximately 15 kg
Display	10.1-inch WXGA (1280 x 800) TFT LCD