16-2
IM WT5000-02EN
Network (VXI-11)
To use the Ethernet interface, you must specify the following TCP/IP settings.
• IP address
• Subnet mask
• Default gateway
For details on setting these parameters, see section 15.2.
USB Settings
• Install the YOKOGAWA USB driver on your PC. For information about how to obtain the
YOKOGAWA USB driver, contact your nearest YOKOGAWA dealer. You can also access the
YOKOGAWA USB driver download web page and download the driver.
http://www.yokogawa.com/jp-ymi/tm/F-SOFT/
• Do not use USB drivers (or software) supplied by other companies.
GP-IB Settings
• When the controller is communicating with the instrument or with other devices through GP-IB,
do not change the address.
• Each device that is connected in a GP-IB system has its own unique address. This address is
used to distinguish between different devices. Therefore, you must assign a unique address to
the instrument when connecting it to a PC or other device.
Command Type
Specify the command type compatible with this instrument or legacy models (WT3000E, WT3000,
WT1800E, WT1800, WT1600).
The response to the *IDN? and *OPT? commands will be according to the model of the specified
command type.
Procedure Using Keys
You can also press UTILITY on the front panel to display the utility settings overview screen.
UTILITY area
The utility settings overview screen appears.
16.1 Remote Control
To Next Page
Loading...
