YOKOGAWA WT5000 User Manual

3-21
IM WT5000-02EN
Switching the Displayed Items (Items)
You can switch the measured value (measurement function) shown in the screen.
3.
Tap Display.
A display format setup screen (Numeric/Graph) appears. For details, see section 3.1.
4.
Tap Items. The following screen appears.
Closes the menu
Set the displayed item.
You can set the following items for displaying computed values (numeric, event).
Computed value (numeric) (User Func group):
F1 to F20 (user-defined function)
Computed value (event) (User Event group):
Ev1 to Ev8 (user-defined event)
Procedure Using the Menu Icons
You can also use the menu icons shown on the right side of the screen to switch the displayed items.
1.
Tap the Display menu icon . A Display menu appears in the sub menu area on the right side
of the screen.
By tapping the displayed items, you can specify the same operation as explained in “Switching the
Displayed Items” described earlier.
Note
For details on the Display menu, see page iv.
3.5 Displaying Computed Values (Values and Events)

YOKOGAWA WT5000 Specifications

General

Frequency Range	DC, 0.1 Hz to 1 MHz
Number of Channels	Up to 7
Interfaces	USB, Ethernet, GP-IB, RS232
Sampling Rate	10 MS/s
Harmonic Analysis	Up to the 500th order
Weight	Approximately 15 kg
Display	10.1-inch WXGA (1280 x 800) TFT LCD