SonTek/YSI
2
ADVField Operation Manual (September 1, 2001)
hardware, ADV, 47
help commands, 25, 28
housing, splash-proof, 2, 53, 56
input signals, 53
installation, 13
instrument mounting, 68
interconnection, system, 13
jumper, communication protocol, 52
jumpers and switches, 51, 63
LD (Dir) command, 40
LISST sensor commands, 43
LISST sensors, 79
LisstBufferSize (LBS) command, 43
LisstSensorInstalled command, 43
maintenance, routine, 87
memory requirements, calculating, 16
MicroCat CTD commands, 41
modes of operation, 21
module, processing, 47
modules, accessing, 56
mounting advice, 85
mounting, instrument, 68
multi-system operation, 82, 107
noise, 89
operational considerations, 81
OutFormat (OF) command, 31
output signals, 53
Paros command, 42
Paros pressure sensor, 76
ParosFreq command, 42
ParosFreq pressure sensor, 77
ping, 8
pinging rate, 8
power requirements, calculating, 16
power supply, changing, 22
PowerOff command, 30
PressFreqOffset command, 42
PressOffset command, 41, 75
PressScale command, 41, 75
pressure sensor, 74
pressure sensors, 76
probe configuration file, 8, 14, 18, 21, 30, 32, 81
probe, 16/10-MHz ADV, 2
probe, 5-MHz ADVOcean, 5
processing module, 47, 56
protocol jumpers, communication, 52
protocol, serial communication, 82
real-time data collection, 14
real-time output, ASCII format, 93
real-time output, binary format, 94
RecordAmpCorr command, 37
RecordCompass command, 37
RecordCTD command, 39
recorder board, 50
recorder commands, 26, 40
RecordExtPress command, 39
RecordExtSensor command, 38
RecordLisst command, 39
RecordSensor command, 38
RecordStat command, 38
RecStatus command, 40
repair information, 91
resonance pressure sensors, 76
RMA information, 91
RS-485, 82
RS485 operation, 107
run time commands, 27, 46
Sal command, 32
salinity, 8
sample, 8
sample on sync, 84
SamplesPerBurst (SPB) command, 37
sampling interval, 8
sampling rate, 8
sampling strategies, 10
sampling volume, 8
SampRate (SR) command, 33, 36
SaveSetup command, 29
SeaBird MicroCat CTD commands, 41
seeding, 86
Sensor command, 41
sensor commands, 27, 41
sensor, mounting and handling, 85
sensor, pressure, 74
sensor, temperature, 74
sensors, integrated, 85
serial communication protocol, 82
SerNum command, 30
Setup command, 31
setup commands, 26, 32
setup, autonomous, 16
setup, real-time, 14
show commands, 27, 45
Show Conf command, 45
Show Deploy command, 46
Show Druck command, 43
Show Parosfreq command, 43
Show Setup command, 45
Show System command, 45
signal conditioning module, 65
signal processing hardware, 1
sleep mode, 22
software installation, 13
sound speed, 8
speed of sound, 8
To Next Page
Loading...
Need help?
General
